Install RAM No-Drill Laptop Mount in Ford F-250

Quick answer

Install the RAM No-Drill Laptop Mount in a Ford F-250 by attaching the base to the passenger seat rail bolts, then assembling the telescoping poles and swing arms for a secure, adjustable workstation.

Installation steps

1. Remove the passenger seat bolts: Slide the passenger seat fully forward. Locate the two front seat rail bolts on the floor. Use a socket wrench to remove them. Keep the bolts safe—you will reuse them. Common mistake: Forgetting to slide the seat forward first, which makes bolt access difficult. Always move the seat fully forward before starting.
2. Position the mount base: Place the RAM No-Drill base plate over the exposed bolt holes. Align the slots in the plate with the holes. Have a helper hold the plate steady while you thread the original bolts back in by hand to avoid cross-threading. Checkpoint: Ensure the base plate is oriented so the mounting post faces the desired direction (toward the center console or dash). Adjust before tightening.
3. Tighten the seat bolts to spec: Use a torque wrench to tighten the seat bolts to the manufacturer's specification (typically 30-40 ft-lb for Ford F-250). Do not overtighten, as this can strip the threads or damage the seat rail. Common mistake: Using a regular wrench instead of a torque wrench. Uneven or excessive torque can loosen over time or damage the bolt. Always use a torque wrench.
4. Assemble the telescoping poles: Insert the lower pole into the base post and secure it with the provided knob. Slide the upper pole into the lower pole and adjust to your desired height. Tighten the knob firmly by hand. Checkpoint: Make sure the poles are fully seated before tightening. A partially inserted pole can slip under load.
5. Attach the dual swing arms and laptop tray: Mount the swing arm assembly to the top of the upper pole. Attach the laptop tray to the swing arm using the supplied hardware. Adjust the arm angles and tighten all pivot knobs. Common mistake: Over-tightening the pivot knobs. Tighten only until the arm holds position without sagging. Overtightening can strip the plastic knobs.
6. Test the mount before use: Place your laptop on the tray and secure it with the locking mechanism. Gently move the swing arms through their full range of motion. Check that all knobs stay tight and the base does not shift. Re-tighten any loose connections. Checkpoint: If the mount wobbles at the base, the seat bolts may need re-torquing. If the swing arm droops, tighten the pivot knobs slightly more—but not past the point of resistance.

Product details

• RAM® No-Drill™ Locking Mount for '99-16 Ford F-250 - F 750 + More: This No-Drill Laptop Stand System installs quickly and easily into the specified vehicles using the existing hardware of the passenger side seat rails. You can mount your laptop without drilling, keeping your Ford F-250's interior unmodified and the installation reversible.

  

• RAM® No-Drill™ Locking Mount for '99-16 Ford F-250 - F 750 + More: Dual swing arms provide articulation and 12 inches of reach for passenger and driver access. Both you and your passenger can easily view and use the laptop, making it practical for collaborative work or navigation.