How to Mount a RAM Mirror-Mate Ball Base on Ford, Chrysler & Toyota
By RAM Mounts Google Search | Published: 2026-10-31
Category: How-to Guides
Install a RAM Mirror-Mate ball base on your Ford, Chrysler, or Toyota by sliding it over the factory windscreen button—no drilling. Follow these steps for a secure mount.
Quick answer
To mount a RAM Mirror-Mate ball base, remove your factory rearview mirror, slide the adaptor over the existing windscreen button, and tighten it in place. This reuses the factory mounting point for a clean, drill-free install on compatible Ford, Chrysler, and Toyota vehicles.
Why the Mirror-Mate is a smart alternative to dash or windshield mounts
The RAM Mirror-Mate ball base solves a common problem: finding a stable mounting point for lightweight electronics without drilling or using suction cups that fail in heat. By replacing the factory mirror button with a ball-equipped adaptor, you get a secure, vehicle-specific foundation that looks factory-installed.
This approach is especially useful for dash cams or small devices that need a high, centered view. Because the adaptor replicates the factory button on the cab-facing side, you can still attach your rearview mirror—no permanent modification required.
Compatibility and what to check before you start
The RAM Mirror-Mate is designed for Chrysler, Ford, and Toyota vehicles that use a standard windscreen button. Before ordering, confirm your mirror attaches via a button glued to the glass—not a torx screw or other proprietary system. If your mirror mounts differently, this adaptor won’t fit.
Also consider the weight of your device. The Mirror-Mate is ideal for lightweight electronics like dash cams or small GPS units. Heavier devices may cause vibration or strain on the button over time.
Step-by-step installation
- Remove the factory rearview mirror: Loosen the set screw (if present) and carefully slide the mirror off the windscreen button. Avoid twisting or prying, which can crack the glass. Check that the button remains firmly glued to the glass; if it’s loose, reattach it with mirror adhesive before proceeding.
- Slide the RAM Mirror-Mate over the factory button: Align the adaptor’s opening with the button and push it on until it seats fully. It should sit flush against the glass. Do not force it—if it doesn’t slide on smoothly, you may have the wrong adaptor for your vehicle.
- Tighten the adaptor in place: Use the provided screw or tightening mechanism to secure the adaptor. Hand-tighten only; over-tightening can damage the button or glass. Gently tug the adaptor to confirm it’s secure before attaching any device.
- Reattach the rearview mirror to the new cab-facing button: Slide your mirror onto the replicated button on the cab-facing side of the adaptor and secure it as you would normally. Verify the mirror is stable and does not obstruct your view.
- Attach your RAM mount arm and device: Connect your RAM arm and device holder to the ball on the Mirror-Mate. Adjust the angle for safe viewing without blocking your line of sight. Test for vibration while driving; if excessive, consider a shorter arm or lighter device.
Product facts
- RAM® Mirror-Mate™ Ball Base for Chrysler, Ford & Toyota: The RAM Mirror-Mate ball base slides over the factory windscreen button and tightens in place, replicating the button on the cab-facing side. This means you can mount your device without drilling and still keep your rearview mirror functional.
RAM® Mirror-Mate™ Ball Base for Chrysler, Ford & Toyota
