How to Install a RAM Transducer Mount with Diamond Base

By RAM Mounts Google Search | Published: 2026-10-24

Category: How-to Guides

Learn how to install the RAM Transducer Mount with Diamond Base for your kayak fish finder. Step-by-step guide for quick deployment and retrieval.

Quick Answer

Install the RAM Transducer Mount with Diamond Base by attaching the diamond base to your kayak, adjusting the 18" aluminum rod for optimal transducer depth, and securing the transducer bracket. This setup allows quick deployment and retrieval without tools.

Why a Deployable Transducer Arm Matters for Kayak Fishing

Kayak fishing demands adaptability. A fixed transducer can get damaged when beaching or navigating shallow water. The RAM Transducer Mount with Diamond Base solves this by letting you deploy and retrieve your transducer quickly, protecting it from impacts. The 18" aluminum rod provides reach and stability, while the diamond base offers a secure mounting point that fits most kayak track systems or flat surfaces.

Choosing the Right Mounting Location

Pick a spot on your kayak where the diamond base can sit flat and clear of obstacles like paddle strokes or gear. The rod should extend freely into the water without hitting the hull. A common mistake is mounting too far forward, where turbulence from the hull can affect sonar readings. Aim for a location near the stern, but within easy reach from your seat.

Installation Steps

1. Attach the Diamond Base: Place the diamond base on your chosen mounting surface. Use the included hardware to secure it firmly. For track systems, slide the base into the track and tighten the locking knob. For flat surfaces, drill pilot holes and use the provided screws. Check that the base is level and tight—any wobble will affect transducer alignment.
2. Assemble the Aluminum Rod and Bracket: Slide the 18" aluminum rod through the diamond base clamp. Attach the transducer bracket to the rod end using the provided bolts. Do not overtighten—you need some adjustability for fine-tuning the transducer angle. Leave the rod clamp slightly loose so you can adjust the rod height later.
3. Mount the Transducer: Secure your fish finder transducer to the bracket using the screws or zip ties that came with your transducer. Ensure the transducer face points straight down and is parallel to the water surface when deployed. A common mistake is mounting the transducer at an angle—this causes inaccurate depth readings.
4. Adjust Rod Depth and Angle: Lower the rod so the transducer sits 1–2 inches below the kayak hull. Tighten the clamp. Rotate the rod to position the transducer directly under the hull or slightly to the side, depending on your sonar beam pattern. Too deep creates drag; too shallow may cause air bubbles that block the signal.
5. Test Deployment and Retrieval: Practice raising and lowering the arm while seated. The diamond base clamp should release easily with one hand. Make sure the rod locks in the up position when not in use. If the arm won't stay up, tighten the clamp slightly—but not so much that it's hard to release.

Product Details

RAM® Transducer Mount with 18" Aluminum Rod and Diamond Base: RAM Mount offers a deployable transducer arm for kayaks, enabling quick deployment and retrieval while protecting the transducer from damage. You can raise the transducer when navigating shallow water or beaching, then lower it again without tools, reducing the risk of costly damage.
RAM® Transducer Mount with 18" Aluminum Rod and Diamond Base